sunshine

View Printer Configuration   ZT410 - I like the "refrigerator light" in this printer!
  +25.0               DARKNESS         
  3.0 IPS             PRINT SPEED      
  +000                TEAR OFF         
  TEAR OFF            PRINT MODE       
  GAP/NOTCH           MEDIA TYPE       
  TRANSMISSIVE        SENSOR SELECT    
  THERMAL-TRANS.      PRINT METHOD     
  1248                PRINT WIDTH      
  1222                LABEL LENGTH     
  41001-97/1408-02598 PRINT HEAD ID    
  39.0IN   988MM      MAXIMUM LENGTH   
  MAINT. OFF          EARLY WARNING    
  NOT CONNECTED       USB COMM.        
  BIDIRECTIONAL       PARALLEL COMM.   
  RS232               SERIAL COMM.     
  9600                BAUD             
  8 BITS              DATA BITS        
  NONE                PARITY           
  XON/XOFF            HOST HANDSHAKE   
  NONE                PROTOCOL         
  NORMAL MODE         COMMUNICATIONS   
  <~>  7EH            CONTROL PREFIX   
  <^>  5EH            FORMAT PREFIX    
  <,>  2CH            DELIMITER CHAR   
  ZPL II              ZPL MODE         
  CALIBRATION         MEDIA POWER UP   
  CALIBRATION         HEAD CLOSE       
  DEFAULT             BACKFEED         
  +000                LABEL TOP        
  +0000               LEFT POSITION    
  DISABLED            REPRINT MODE     
  050                 WEB SENSOR       
  080                 MEDIA SENSOR     
  052                 RIBBON SENSOR    
  050                 TAKE LABEL       
  027                 MARK SENSOR      
  027                 MARK MED SENSOR  
  002                 TRANS GAIN       
  017                 TRANS BASE       
  058                 TRANS LED        
  001                 RIBBON GAIN      
  255                 MARK GAIN        
  043                 MARK LED         
  DPCSWFXM            MODES ENABLED    
  ........            MODES DISABLED   
  1248 12/MM FULL     RESOLUTION       
  2.0                 LINK-OS VERSION  
  V75.19.7Z <-        FIRMWARE         
  1.3                 XML SCHEMA       
  6.5.0 0x0012.0x0047 HARDWARE ID      
  4096k............R: RAM              
  65536k...........E: ONBOARD FLASH    
  NONE                FORMAT CONVERT   
  FW VERSION          IDLE DISPLAY     
  05/16/17            RTC DATE         
  19:58               RTC TIME         
  DISABLED            ZBI              
  2.1                 ZBI VERSION      
  READY               ZBI STATUS       
  3,075 LABELS        NONRESET CNTR    
  3,075 LABELS        RESET CNTR1      
  3,075 LABELS        RESET CNTR2      
  16,300 IN           NONRESET CNTR    
  16,302 IN           RESET CNTR1      
  16,302 IN           RESET CNTR2      
  41,407 CM           NONRESET CNTR    
  41,407 CM           RESET CNTR1      
  41,407 CM           RESET CNTR2      
  EMPTY               SLOT 1           
  EMPTY               SLOT 2           
  0                   MASS STORAGE COUNT
  0                   HID COUNT        
  OFF                 USB HOST LOCK OUT

Is your printer only 203 dpi. Ours are 300 dpi.  I  am looking at the manual. It says accepted value for  ZT410 Print Width 203 dpi = 0002 to 832. I don't see anything about max for label length.

I need help from softbank users on setting up issuing only type A plasma for emergency issue regardless of patients blood type.